Physical Interfaces & Cabling: practice questions

Copper and fiber cabling, interface speed and duplex, and reading interface counters to find cabling and mismatch problems.

CCNA 200-301 v1.1, exam topic 1.3-1.4 · part of 1. Network Fundamentals, 20% of the exam

The same material in the CCNA 200-301 v2.0 exam: Interface & Cable Issues

What this topic covers

Copper and fiber
Twisted-pair copper reaches 100 m; multimode fiber suits shorter runs and single-mode fiber the longest.
Speed and duplex mismatches
A half-duplex end sees late collisions and the full-duplex end sees CRC errors and runts.
Pinouts and cable types
Straight-through and crossover cables, and auto-MDIX ports that adapt to either.
Interpreting counters
Errors, drops and status indicators.
CSMA/CD
Stations listen before sending, detect collisions and retry after a random exponential backoff.

Sample question

Try it, then open the answer. Our questions are written by AI and checked independently before they are published.

Medium Single choice

Refer to the exhibit. At which layer of the OSI model does the operational failure reside on GigabitEthernet0/1?

Interface Status
R1# show interfaces GigabitEthernet0/1
GigabitEthernet0/1 is up, line protocol is down
  Hardware is ISR4331-1x1GE, address is 00a3.d144.1201 (bia 00a3.d144.1201)
  MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec,
     reliability 255/255, txload 1/255, rxload 1/255
  Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 1000Mb/s, link type is auto negotiation, media type is RJ45
  output flow-control is unsupported, input flow-control is unsupported
  ARP type: ARPA, ARP Timeout 04:00:00
  Last input 00:00:03, output 00:00:02, output hang never
  Last clearing of "show interface" counters never
  Input queue: 0/375/0/0 (size/max/drops/flushes); Total output drops: 0
  Queueing strategy: fifo
  Output queue: 0/40 (size/max/drops); Total output drops: 0
  5 minute input rate 2000 bits/sec, 3 packets/sec
  5 minute output rate 0 bits/sec, 0 packets/sec
     1842 packets input, 196714 bytes, 0 no buffer
     Received 1206 broadcasts (0 IP multicasts)
     0 runts, 0 giants, 0 throttles
     0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
     0 watchdog, 0 multicast, 0 pause input
     28 packets output, 2240 bytes, 0 underruns
     0 output errors, 0 collisions, 0 interface resets
     0 unknown protocol drops
     0 babbles, 0 late collision, 0 deferred
  1. A. Physical layer
  2. B. Network layer
  3. C. Transport layer
  4. D. Data Link layer
Show the answer

Answer: D. Data Link layer

In Cisco IOS interface output, the first status field reflects the Physical layer (carrier detect and hardware signaling), while the line protocol status reflects the Data Link layer (framing, keepalives, and Layer 2 handshaking). GigabitEthernet0/1 is up and is receiving frames, 1842 packets input with no input errors, so the Physical layer works. Its line protocol is down, so Layer 2 communication has failed.

Further reading