Static Routing: practice questions

IPv4 and IPv6 static routes: default, network, host and floating static routes, and finding a static routing fault.

CCNA 200-301 v2.0, exam topic 3.2 · part of 3. IP Routing, 20% of the exam

The same material in the CCNA 200-301 v1.1 exam: Static Routing

What this topic covers

Static route basics
Manually configured routes that do not adapt to failures.
Default route purpose
Where to send packets with no more specific match.
Host routes
A /32 IPv4 or /128 IPv6 route to a single address.
Floating static routes
A static route with a higher administrative distance than the route it backs up, used only when that route disappears.
IPv6 static routes
IPv6 network and default (::/0) routes; a link-local next hop must be paired with the exit interface.
Dual stack
Running IPv4 and IPv6 together on the same interfaces during transition.

Sample question

Try it, then open the answer. Our questions are written by AI and checked independently before they are published.

Easy Single choice

What is the primary purpose of a default static route?

  1. A. forwarding traffic exclusively for local subnet hosts
  2. B. matching any destination address not found in the routing table
  3. C. translating private IP addresses to public internet addresses
  4. D. dropping all packets lacking a specific routing table entry
Show the answer

Answer: B. matching any destination address not found in the routing table

A default static route uses the destination prefix 0.0.0.0/0, which matches any IP address. When a router receives a packet for a destination that has no more specific match in the routing table, it forwards the packet using the default route.

Further reading