Interswitch Connectivity: practice questions

Trunk ports, 802.1Q, the native VLAN and the VLANs a trunk allows, and routing between VLANs with SVIs.

CCNA 200-301 v2.0, exam topic 2.1 · part of 2. Switching and Network Access, 25% of the exam

The same material in the CCNA 200-301 v1.1 exam: Interswitch Connectivity

What this topic covers

Trunk links
Links that carry frames for multiple VLANs using tags.
Native VLAN
Frames on the trunk's native VLAN travel untagged, so both ends must agree on it.
Allowed VLANs
A trunk carries only the VLANs allowed on it, which limits how far each VLAN's broadcasts reach.
Routing between VLANs
Traffic between VLANs needs routing: a router subinterface per VLAN, or a switch virtual interface on a Layer 3 switch.

Sample question

Try it, then open the answer. Our questions are written by AI and checked independently before they are published.

Medium Single choice

Refer to the exhibit. Switch SW1 receives a frame tagged with VLAN 30 on GigabitEthernet0/1. How does SW1 handle the frame?

SW1 Configuration
Building configuration...

Current configuration : 94 bytes
!
interface GigabitEthernet0/1
 switchport trunk encapsulation dot1q
 switchport mode trunk
 switchport trunk allowed vlan 10,20,40
end
  1. A. drops the frame because the VLAN is not in the allowed list
  2. B. processes the frame using the native VLAN fallback
  3. C. forwards the frame out all other trunk ports
  4. D. strips the 802.1Q tag and forwards the frame to access ports
Show the answer

Answer: A. drops the frame because the VLAN is not in the allowed list

Switch SW1 inspects the incoming frame's 802.1Q tag, which indicates VLAN 30. Looking at the interface configuration for GigabitEthernet0/1, the allowed VLAN list is explicitly restricted to VLANs 10, 20, and 40. Because VLAN 30 is not permitted on this trunk link, SW1 drops the frame.

Further reading