Two or more routers share a virtual IP and MAC address that hosts use as their default gateway.
HSRP and VRRP
HSRP, one vendor's proprietary protocol, elects an active and a standby router; VRRP, the IETF standard, elects a master and backups.
Priority and preemption
The highest priority router serves the virtual address; with preemption it takes the role back when it recovers.
Sample question
Try it, then open the answer. Our questions are written by AI and checked independently before they are published.
MediumSingle choice
Refer to the exhibit. Routers R1 and R2 connect to the same LAN segment on GigabitEthernet0/1 to provide default gateway redundancy for 192.168.1.0/24. What is the cause of both routers operating in the Active state?
R1# show standby brief
P indicates configured to preempt.
|
Interface Grp Pri P State Active Standby Virtual IP
Gi0/1 10 110 P Active local unknown 192.168.1.1
R2# show standby brief
P indicates configured to preempt.
|
Interface Grp Pri P State Active Standby Virtual IP
Gi0/1 20 100 Active local unknown 192.168.1.1
A. HSRP group numbers mismatch across the routers
B. HSRP preemption is disabled on R2
C. virtual IP addresses belong to different subnets
D. HSRP priority values are equal on both routers
Show the answer
Answer: A. HSRP group numbers mismatch across the routers
In HSRP, routers exchange hellos scoped to a specific standby group number. The output shows R1 configured for group 10 ('Grp 10') and R2 configured for group 20 ('Grp 20'). Because the group IDs do not match, neither router recognizes the other's HSRP hello messages, leading both to believe no other active router exists and report 'Standby unknown' while remaining Active.