First Hop Redundancy: practice questions

First hop redundancy protocols, such as HSRP and VRRP, which let routers share a virtual default gateway, with priority and preemption.

CCNA 200-301 v2.0, exam topic 3.4 · part of 3. IP Routing, 20% of the exam

The same material in the CCNA 200-301 v1.1 exam: First Hop Redundancy

What this topic covers

Virtual default gateway
Two or more routers share a virtual IP and MAC address that hosts use as their default gateway.
HSRP and VRRP
HSRP, one vendor's proprietary protocol, elects an active and a standby router; VRRP, the IETF standard, elects a master and backups.
Priority and preemption
The highest priority router serves the virtual address; with preemption it takes the role back when it recovers.

Sample question

Try it, then open the answer. Our questions are written by AI and checked independently before they are published.

Medium Single choice

Refer to the exhibit. Routers R1 and R2 connect to the same LAN segment on GigabitEthernet0/1 to provide default gateway redundancy for 192.168.1.0/24. What is the cause of both routers operating in the Active state?

R1# show standby brief
                     P indicates configured to preempt.
                     |
Interface   Grp  Pri P State   Active          Standby         Virtual IP
Gi0/1       10   110 P Active  local           unknown         192.168.1.1
R2# show standby brief
                     P indicates configured to preempt.
                     |
Interface   Grp  Pri P State   Active          Standby         Virtual IP
Gi0/1       20   100   Active  local           unknown         192.168.1.1
  1. A. HSRP group numbers mismatch across the routers
  2. B. HSRP preemption is disabled on R2
  3. C. virtual IP addresses belong to different subnets
  4. D. HSRP priority values are equal on both routers
Show the answer

Answer: A. HSRP group numbers mismatch across the routers

In HSRP, routers exchange hellos scoped to a specific standby group number. The output shows R1 configured for group 10 ('Grp 10') and R2 configured for group 20 ('Grp 20'). Because the group IDs do not match, neither router recognizes the other's HSRP hello messages, leading both to believe no other active router exists and report 'Standby unknown' while remaining Active.

Further reading